Front Panel - Panasonic YD-500GP5 Operating Instructions Manual

5.3 Front panel

Note:
for robot welding, be sure to set the machine on " crater OFF " status.
NO. name
temperature
○
1
abnomal indicator
current display
○
2
7-segment LED
setting
" current "
" wire feeding
speed "
○ " plate thickness "
3
" spot welding
time "
function 的
select
Names and functions
● When abnormal rise in important components temperature occurs, temperature
abnomal alarm is sent, this lamp blinks and the welding operation stops. Welding
operation cannot be restarted unless this lamp is turned off. ( For troubleshooting:
Section 13.1).
● When Mode selection key ○
・On stand-by status,, it shows the current value set in
・During welding, it shows the current value of the actual output.
● When Mode selection key ○
・It shows fine adjusting setting items PXX(XX stands for 00->29), default display
CH-OFF( voltage display LED○
● When Mode selection key ○
・The default display CH-OFF. By turning the Jog-dial ○
LED shows "CH" channel. If welding parameters are available, the channel can be
selected, else the corresponding channel can NOT be selected. When the channel
stored with data is selected, the channel and parameters are displayed alternately
and welding can start.
● When Mode selection key ○
・By turning the Jog-dial ○
setting current and voltage. Flashing means welding parameters are being stored.
・Press selection key ○
12
parameters are recorded in the channel being selected.
● When a self-diagnosable error occurs, ( For troubleshooting:
・ it shows Err( voltage display LED○
● When " current " / " wire feeding speed " function is selected, the setting method of
the corrosponding selection number is decided by P11 of "F. Adj" function menu.
When P11 is 0, it is adjusted by wire feeder potentiometer; when P11 is 1, it can
be changed by Jog-dial ○
of being changed.
● " spot welding time " function is adjusted by Jog-dial ○
Note To change" spot welding time ", welding control
welding " function.
description
is set to" Weld "
12
is set to"F. Adj" (
12
shows its specific set value ).
5
is set to " Call " (
12
is set to " Record " (
12
, channel number can be selected. LED shows "CH"
7
to return to " Weld " from " Record " and the corresponding
shows alarm signal number ).
3
. Note " plate thickness " can be displayed only instead
4
17
○
3
Section 5.4)
Section 5.6)
, select channel number,
7
Section 5.6)
Section 13.1)
.
4
○
is to be selected as " spot
13