Remote Mounting without the Mounting
Kit
Note:
See
Figure 27.
for the dimensions and
the item locations referenced in steps
1 – 8.
1. At the EOI mounting location, mark the 3.80" by
3.56" hole and the four 7/32" screw holes.
2. Cut the 3.80" by 3.56" rectangular mounting hole.
3. Drill the four 7/32" screw holes.
4. Remove the Front Panel Assembly of the ASD —
using a flathead screwdriver, release the upper
retaining tabs of the EOI panel. Then pivot the
Figure 27. EOI Remote Mounting Dimensions (inches/millimeters).
https://www.toshiba.com/tic/
EOI Remote Mounting
Q9 Plus ASD Install/Op Manual
EOI assembly away from the ASD and lift (see
Figure
25.).
5. Remove the EOI from the Front Panel Assembly
of step 4 — discard the assembly.
6. Attach and secure the EOI to the front side of the
mounting location using the four 6-32 x 5/16" pan
head screws, the #6 split lock washers, and the
#6 flat washers.
7. Install the Front Panel Connector Assembly to
the ASD (see
Figure
25.).
8. Connect the Extender Cable from the EOI to the
Front Panel Assembly.
27