Table of Contents
Advertisement
Installation and Connections
Q9 Plus ASD Install/Op Manual
I/O and Control
The ASD can be controlled by several input types
and combinations thereof, as well as operate within
a wide range of output frequency and voltage
levels. This section discusses the ASD control
methods and supported I/O functions.
The Terminal Board supports discrete and analog
I/O functions and is shown in
Table 2
lists the names, descriptions, and default
Terminal
Input/Output
Name
ST
RES
Discrete
F
Input
Connect to
R
CC to
S1
activate (Sink
mode).
S2
S3
S4
O1A/B (OUT1)
O2A/B (OUT2)
Switched
Output
FLA
Contacts
FLB
FLC
RR
RX
Analog
Input
V/I
(Select V or I
via SW301)
AM
Analog
Output
FM
14
Figure 9. on pg. 17.
Table 2. Terminal Board Names and Functions.
Function (Default Setting If Programmable)
(see
Terminal Descriptions on pg.
Standby — Multifunctional programmable discrete input.
Activation required for normal ASD operation.
Reset — Multifunctional programmable discrete input.
Activation resets ASD when Faulted — ignored when not
Faulted.
Forward — Multifunctional programmable discrete input.
Reverse — Multifunctional programmable discrete input.
Fire Speed — Multifunctional programmable discrete input.
Preset Speed Bit 2 — Multifunctional programmable
discrete input.
Damper Feedback — Multifunctional programmable
discrete input.
Emergency Off — Multifunctional programmable discrete
input.
Damper Command — Multifunctional programmable
discrete form A output contacts.
Reach Frequency — Multifunctional programmable discrete
form A output contacts.
Fault relay (N.O.).
Fault relay (N.C.).
Fault relay (Common).
Frequency Mode 1 — Multifunctional programmable analog
input. (0.0 to 10 volt input — 0 Hz to Maximum Frequency).
Unassigned — Multifunctional programmable analog input
(-10 to +10 VDC input).
Unassigned — V — Multifunctional programmable isolated
analog voltage input (0 to 10 VDC input).
Frequency Mode 2 — I (Default setting) — Multifunctional
programmable isolated analog current input (4 [0] to 20
mADC input — 0 Hz to Maximum Frequency).
Output Current — Current or Voltage output that is
proportional to the output frequency of the ASD or to the
magnitude of the function assigned to this terminal (see
Table 10 on page
255).
Output Frequency — Current or Voltage output that is
proportional to the output frequency of the ASD or to the
magnitude of the function assigned to this terminal (see
255). Select Current or Voltage at F681.
Table 10 on page
settings (of programmable terminals) of the input
and output terminals of the Terminal Board.
Note:
To use the input lines of the Terminal
Board to provide Run commands, the
Command Mode setting must be set to
Terminal Block.
Figure 20. on pg. 19
shows the typical connection
diagram for the Q9 Plus ASD system.
15)
https://www.toshiba.com/tic/
Circuit Config.
Figure 10. on pg. 18.
Figure 16. on pg. 18.
Figure 19. on pg. 18.
Figure 11. on pg. 18.
Figure 12. on pg. 18.
Figure 13. on pg. 18.
Figure 18. on pg. 18
Advertisement
Table of Contents
