Table of Contents
Advertisement
Frequency Priority Selection
Program Fundamental Standard Mode Selection
Either Frequency Mode 1 or Frequency Mode 2 may control the
output frequency of the ASD. This parameter determines which of
the two will control the output frequency and the conditions in
which control will be switched from one to the other.
Note: Frequency Mode is abbreviated as FMOD.
The Frequency Mode 1 or Frequency Mode 2 selection specifies
the source of the input frequency command signal. These selec-
tions are performed at
F004
If FMOD changed by Terminal Board is selected here, the ASD
will follow the control of the discrete input terminal assigned the
function of Frequency Priority. The discrete terminal Frequency
Priority will toggle control to and from Frequency Mode 1 and Fre-
quency Mode 2 with each activation/deactivation.
If FMOD (F208) is selected here, the ASD will follow the control
of the Frequency Mode 1 setting for the duration that the com-
manded frequency of the Frequency Mode 1 setting is greater
than the setting of F208.
If the commanded frequency of the Frequency Mode 1 setting is
less than or equal to the setting of
setting of
Frequency Mode 2.
Settings:
0 — FMOD changed by Terminal Board (Frequency Mode)
1 — FMOD (F208) (Frequency Mode)
https://www.toshiba.com/tic/
–
F200
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
and F207, respectively.
F208, the ASD will follow the
F201
Direct Access Number —
Parameter Type — Selection List
Factory Default — FMOD
(changed by TB)
Changeable During Run — Yes
F200
103
Advertisement
Table of Contents
