Spare Parts; Decommissioning; Disassembly And Replacement; Preparing The Product For Storage/Later Use - Bosch Rexroth HQ 2/C-H Assembly Instructions Manual

56/64

Decommissioning

Bosch Rexroth AG, Material and information fl ow technology: HQ 2/C-H, HQ 4, 3 842 358 792/2016-12

10.4.5 Spare parts

For a list of spare parts, see MTparts, 3 842 529 770.
11 Decommissioning
This product does not need to be decommissioned. Accordingly, this section has
been left blank.

12 Disassembly and replacement

High electrical voltage!
Risk of serious injury or death from electric shock.

Disconnect the relevant system component before performing maintenance or
servicing.

Secure the system against unintended reactivation.
High pneumatic pressure is present!
Risk of serious injury or death.

Switch off the compressed air supply to the relevant system component before
undertaking any maintenance or servicing.

Secure the system against unintended reactivation.
Raised loads may fall!
Falling objects can result in serious injury (or even death).

Only use slings with a suffi ciently high bearing load (see shipping documents for
product weight).

Make sure the lifting straps are correctly fastened before lifting the product.

Secure the product against tipping when lifting.

Make sure no one but the operator is in the danger zone when lifting and lowering.

12.1 Preparing the product for storage/later use

• Only set the product down on a fl at surface.
• Protect the product from mechanical stress.
• Protect the product from environmental infl uences, such as dirt and moisture.
• Pay attention to the ambient conditions, see page 58.
• For products with ready-mounted motor: Support the product so that the motor is
not placed under mechanical load.
WARNING