Table of Contents
Advertisement
C-7D
Programming
STEP 1:
ANPD - Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H)
and Busy (B). Assign NND in accordance with a predetermined numbering plan.
STEP 2:
ASPA - Assign an access code for the CALL PICKUP GROUP, SID = 7 and the CALL PICKUP
EXPAND, SIDA=63 (if necessary) for Connection Status Index (CI) of Normal (N) and Hooking (H).
STEP 3:
ACPG - Assign members of CALL PICKUP GROUP. If two stations are ringing simultaneously, the
station that was programmed first will be picked up first.
STEP 4:
ACPE - Assign the CALL PICKUP EXPAND GROUP (if necessary).
STEP 5:
AKYD - Optional. Assign a programmable Line/Feature key as a CALL PICKUP key. Assign
Type:Function:CALL PICKUP-GROUP [12]. If necessary, assign Type:Function:CALL PICKUP
EXPAND [115].
STEP 6:
ADSL - Assign SN=1 (Originating) and FKY=12 (Call Pick-up Group; PICK).
When answering an incoming call while the user is on the line, assign SN=4 (Communication is in
Progress) and FKY=12 (Call Pick-up Group; PICK).
This command is required only for assigning the function of each soft key.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ANPDN - This command must be assigned to the NCN.
Reserve a number level for feature access and cancel. Assign for normal (N).
Assign NND in accordance with a predetermined plan.
STEP 2:
ASPAN - This command must be assigned to the NCN. Assign access code for CALL PICKUP,
CI=N, SRV=SSC, SID=7 (CALL PICKUP - GROUP). If necessary, assign SRV=SSCA, SIDA=63
(CALL PICKUP EXPAND GROUP).
CI=N (Normal)
SRV=SSC
SID=7 (CALL PICKUP GROUP)
STEP 3:
ACPGN - This command must be assigned to the NCN.
Assign members of CALL PICKUP GROUP.
UGN: User Group Number
TELN: Telephone number in CALL PICKUP GROUP
STEP 4:
ACPEN - This command must be assigned to the NCN.
Assign the CALL PICKUP EXPAND GROUP (if necessary).
UGN: User Group Number
TELN: Telephone number in CALL PICKUP EXPAND GROUP
When using a feature key, the feature key data is assigned to all the nodes accommodated in the Call Pickup
Note:
station by the AKYD command.
When Entering Data via LDM
STEP 1:
ANPDL - Assign 1st digit code (1st DC) and number of necessary digits (NND) for feature access and
cancel. CI = N (Normal).
STEP 2:
ASPAL - Assign access code for CALL PICKUP, CI=N, SRV=SSC, SID=7 (CALL PICKUP -
GROUP). If necessary, assign SRV=SSCA, SIDA=63 (CALL PICKUP EXPAND GROUP).
Page 154
Call Pickup - Group - D
term
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
