Table of Contents
Advertisement
I-18
I-18
General Description
This feature allows calls to be transferred from one Attendant Console to another through the CCIS network.
Operating Procedure
To transfer from Console A to Console B
1.
Attendant A presses the START key.
2.
Attendant A dials the Attendant Console B Identification Number, or "0" for all Attendant Consoles.
3.
The call is indicated at Attendant Console B or all Attendant Consoles.
4.
Attendant B presses the ANSWER key.
5.
Attendant A presses the RELEASE key to transfer; or consults first and then releases.
Service Conditions
1.
An Identification Number is assigned to each Attendant Console for INTER-POSITION TRANSFER -
CCIS.
2.
An Attendant Console can receive one INTER-POSITION TRANSFER call at a time. An INCOMING
CALL IDENTIFICATION - CCIS [I-16] key is designated for receipt of these calls.
3.
An Attendant cannot transfer a two-party connection to another Attendant.
4.
An Attendant can extend an INTER-POSITION TRANSFER - CCIS call to any other destination.
5.
When NIGHT CONNECTION [N-15, N-16] is active in one system, an INTER-POSITION TRANSFER
from the Attendant of another system can be answered by the Night station.
Interactions
1.
The Attendant Console must first be programmed.
2.
An Attendant is allowed to call the ASAT number of another Attendant Console for the purpose of
conversation.
3.
The ASAT number may not be programmed in the place of a telephone number in the ASID and ASGD
commands. See OFF-HOOK ALARM [O-6], ATTENDANT NIGHT TRANSFER [A-19], and
PRIORITY CALL [P-9].
Programming
STEP 1:
ASYD - System Data 2, Index 6, Bit 5. Enable INTER-POSITION TRANSFER? 0/1: No/yes. Assign
data "1". (Assigned on a per-tenant basis.)
System Data 2, Index 9, Bit 3. Is INTER-POSITION TRANSFER considered an incoming call to the
Attendant Console, which is counted as a Call Waiting? 0/1: No/Yes. See CALL WAITING LAMP
[C-13]. (Assigned on a per-tenant basis.)
STEP 2:
ASAT - Assign a specific Attendant number to each Attendant Console.
STEP 3:
ATNR - Allow station-to-station connection on an Intra and Inter-tenant basis.
Page 926
Inter-Position Transfer - CCIS
Inter-Position Transfer - CCIS
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
