Table of Contents
Advertisement
4-2. TAPE Maintenance Mode (M0)
4-2-7. RF ADJUST Mode (A1)
Description of superimposed display
RF ADJUST MODE
A11:EQUALIZER
1
Auto Adjust (Push SET)
ch
RSLT
2
A2
A6
3
*
ALL
Ex. A11 : EQUALIZER
1 The display in this line changes. Each display and its
meaning are described below.
Auto Adjust(Push SET) : Press the SET button to
Insert SR5-1 :
Auto Tracking ... :
Auto Adjusting ... :
Auto Adjust Complete : Automatic adjustment is
Ä
Û
Ô Ô Ô Ô Ô Ô Ô Ô Ô ˝ @ı /˝
M (Å â- ˝ /˝ S (
,ù Óâ-Ä˝ /˝ Q (Å-
·
¸
Ä
displayed while pressing the STOP button except in
adjusting.
n
Do not press the STOP button in adjusting. If pressing
it in adjusting, the tape stops and the automatic
adjustment becomes impossible.
4-44
ch
RSLT
B2
B6
initiate the automatic
adjustment.
Insert an alignment tape.
Tracking is in an optimiza-
tion process.
Automatic adjustment is in
progress.
comp ÄÛ ˛
Û ˛ Ä Û ˛ Ä Û ˛ Ä Û
Ô Ô Ô Ô Ô Ô /
« ·¿p„‡˝ /˝
â-@˝ /˝ Q +
â-@
/˝
â-Ä˝ ˝ S (Å
â ¸ ˝ M!
3 To perform the automatic adjustment for all channels
(circuit) at a time, select "ALL" using the * mark.
During the check, the adjustment result in each
channel is displayed in area 2.
After the automatic adjustment in all channels is
completed, the adjustment result (OK, NG, or FAIL)
will be displayed on the right of "ALL".
"OK":
When all channels (circuits) are "OK"
"NG":
If both "NG" and "OK" occur in channels
"FAIL": If one or more "FAIL" occur in channels
To execute the adjustment
(1) Insert the specified cassette tape.
m
. Be sure to use the specified alignment tape.
If the specified cassette tape is not used, the adjust-
ment cannot be properly performed even if the
message "Auto Adjust Complete" is displayed on
completing the adjustment. Insert alignment tape
SR5-1 (for 525/60 system) or SR5-1P (for 625/50
system).
. Take care that the tape transport mode does not
change during automatic adjustment.
Any adjustment cannot be properly performed in
modes other than tape transport that was set auto-
matically. Moreover, in modes other than tape
transport, the automatic adjustment cannot be
performed any longer or "FAIL" or "NG" is dis-
played as the adjustment result. Therefore, pay
attention to the transport start position of the tape so
that the end and beginning of the tape are not
detected during adjustment. The minimum tape
amount required for normal automatic adjustment is
˚
Ä
shown in the table on the next page. However, the
tape amount increases or decreases when abnormali-
ty occurs.
ˇ
ø
DNW-A22/A22P
™
Æ
Advertisement
Table of Contents
