Table of Contents
Advertisement
1-6. Rack Mounting
1-6. Rack Mounting
Explains how to mount this unit into a 19-inch standard
rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
c
. Use the specified rack mount rail.
The use of other rail of low-strength may drop the unit
and cause the risk of injury.
. To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
. Mounts the unit into a rack with a steady posture.
n
. When other equipment with built-in hard disk drive are
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
. Do not operate this unit without the upper lid and bottom
plate except when servicing it.
. To reduce an increase in the internal temperature of this
unit, leave a space on the top or bottom of this unit by
1U.
. Adjust the temperature inside the rack within the range
of the unit's operating temperature.
Specified Rack Mount Kit
RMM-111 (Optional accessory) or
RMM-110 (Optional accessory)
The color of rack angle of RMM-111 fits to the unit.
RMM-110 is the same consistance, strength and dimension
as RMM-111, but the color of rack angle is different.
n
To mount this unit in the FLEXICART, it is recommended
to use the BKFC-53/2.
1-4
Parts Packed in RMM-110/111
. Slide rails ......................................... 2
. Rack angles (handles) ..................... 2
. Rail brackets .................................... 4
. Plate nuts (large) ............................. 4
. Plate nuts (small) ............................. 4
. Screws (PSW4 x 16) ...................... 4
. Screws (B4 x 8) .............................. 8
. Hexagon socket head cap screws .... 8
. Flat washers ..................................... 8
. Screws (RK5 x 14) ......................... 2
. Ornamental washers ........................ 2
. L-shaped hexagon wrench............... 1
Rack Mounting Procedure
. . . . . Removing the feet
1. Set the unit with its side panel down.
n
Lend your hand so that the lower handle does not hang
down.
2. Unscrew the four screws to remove the feet from the
bottom plate of the unit.
3. Set the unit in a horizontal position.
Foot
PS4 x 14
Foot
n
Keep these screws and the feet.
When operating the unit after demounting it from the rack,
be sure to reattach the feet.
Tightening torque: 98 x 10
PS4 x 14
_2
N . m {10 kgf . cm}
DNW-A22/A22P
Advertisement
Table of Contents
