1-4-3. VC-266 (VC-266P) Board
1. Remove the pan cabinet (side). (Refer to Section 1-2-1)
2. Remove the pan cabinet (front). (Refer to Section 1-2-2)
3. Remove the pan cabinet (rear). (Refer to Section 1-2-3)
4. Remove the camera cabinet (upper/lower). (Refer to
Section 1-2-4)
5. Remove the camera cabinet (front). (Refer to Section
1-2-5)
6. Remove the camera block. (Refer to Section 1-3)
7. Remove the three screws, then remove the VC-266
(VC-266P) board.
8. Disconnect the two flexible flat cables from the two
connectors on the VC-266 (VC-266P) board.
VC-266 (VC-266P)
board
Flexible flat cable
9. Attach the VC-266 (VC-266P) board in the reverse
order of steps 1 to 8.
EVI-D100/EVI-D100P
Connectors
Flexible flat cable
M2
1-4-4. MC-134 Board
1. Remove the pan cabinet (side). (Refer to Section 1-2-1)
2. Remove the pan cabinet (front). (Refer to Section 1-2-2)
3. Remove the pan cabinet (rear). (Refer to Section 1-2-3)
4. Remove the camera cabinet (upper/lower). (Refer to
Section 1-2-4)
5. Remove the camera cabinet (front). (Refer to Section
1-2-5)
6. Remove the camera block. (Refer to Section 1-3)
7. Remove one screw, then remove the MC-134 board
from the groove of the camera block (portion A) in the
direction indicated by the arrow.
8. Disconnect the three flexible flat cables from the three
connectors on the MC-134 board.
Flexible flat cable
2x4
MC-134 board
Connectors
Flexible flat cables
9. Attach the MC-134 board in the reverse order of steps
1 to 8.
Camera block
Portion A
1-7