Ignite-Ux Distribution Media; Hardware Requirements For The Ignite-Ux Server And Clients - HP 9000 Manual

Ignite-UX Distribution Media

Hardware Requirements for the Ignite-UX
Server and Clients
Note that HP-UX 10.30 is not supported on Class B, C, J, or Series 7xx
systems. NFS Diskless functionality is not supported in HP-UX Release
10.30. Do not update your server to HP-UX Release 10.30 if you intend for
that server to operate as a NFS Diskless server. You may find references
within this documentation to NFS Diskless functionality. These references
only apply to systems running HP-UX Release 10.20 or earlier.
To install HP-UX 10.x you will need the following:
Computer An HP 9000 Series computer with PA 1.1 or later
processor.
To check whether your system belongs to the old Series
800 designation, use the uname -a command on a
running system.
Memory For any system installed using Ignite-UX, the required
minimum is 32 MB. (Some older Series 800 models
(PA1.0 processor), such as 8x5 are not supported.) Your
HP sales engineer can assist in determining the proper
amount of RAM.
Information on RAM requirements is also available on
the following web site:
http://www.hp.com:80/computing/mvp/memory.
html.
Source Device Make sure that your system has an appropriate source
(CD-ROM, DDS drive, or LAN card). Ensure that tape
drive heads are clean.
Disk Drive A target system needs at least one hard-disk drive with
at least the following capacities: (The Ignite-UX
program performs an analysis of disk space needed
prior to loading the software.)
Chapter 4
Configuring an Ignite-UX Server
Ignite-UX Distribution Media
63