HP 9000 Manual page 125

Message(s) or
Behavior
Load command
failed:
load_command
Problem
executing
command: command
Problem
executing
command to set
default:
default_cmd
Chapter 6
Possible Cause
This error occurs if
the command used to
load software has
failed during the
load. Such failure can
be due to a problem
with the media or
the source
specification.
This error occurs if
the command used to
configure the
software which has
just been loaded fails.
This error occurs if
the command used to
set the default
release fails.
Typically this
command is
manage_index.
Troubleshooting
Likely Problem Areas
Fix
Refer to the log file
for the command
used to load software.
If make_depots is
used its log file is
under
/var/opt/ignite/
logs.
Refer to the log file
for the command
used to configure
software. If
make_config is
used, its log file is
under
/var/opt/ignite/
logs.
Refer to the log file
for the command
used to configure
software. If
manage_index is
used, its log file is
under
/var/opt/ignite/
logs.
125