Panasonic LP-GS Series Serial Communication Command Manual page 29

⿎ Communication sequence when the marking end verification (MST) command response is
enabled
The laser marker transmits the response data automatically upon completing the marking trigger processing (at the end of
marking) with the response permission setting of the marking end verification (MST) command.
This response data indicate that the marking trigger processing of the laser marker completed normally or ended
abnormally by an error.
For more information on this command, refer to "3-3-10 Marking end verification: MST" (P.69).
• When the response permission of the marking end verification (MST) command is set
External device
Verify the marking
status response
before sending these
commands.
Marking end verification command
(Response permission specified): MSTS1
Positive response: MSTA
Shutter (open) command: SHTS1
Positive response: SHTA
Marking trigger command: MRKS
Positive response: MRKA
Marking status response (marking completed normally):
MSTA000
Marking trigger command: MRKS
Positive response: MRKA
Marking status response (abnormal end by an error):
MSTA...
Shutter (close) command: SHTS0
Positive response: SHTA
ME-LPGS-SR-5
Laser marker
Marking
An alarm or a
warning occurred
during marking
trigger processing
29