Panasonic LP-GS Series Serial Communication Command Manual page 175

ERROR
CODE
Interlocking laser marker internal processing
was not completed successfully using the
E620 - E621
link function with external devices. Trigger
processing terminated abnormally.
I/O connector TIMING IN was not input within
the time specified using the link function with
E622
external devices. Trigger processing terminated
abnormally.
Timing input is invalid.
When the linkage function with external devices
E623 is used, TIMING IN terminal was input while the
timing standby output (TIMING WAIT OUT) was
OFF.
A communication error occurred with an
E624 - E626 external device. Trigger processing terminated
abnormally.
Code reading/checking failed when the code
reading function is used for the link control with
E627
external devices. No available settings for the
code checking.
Code reading failed when the code reading
E628 function is used for the link control with external
devices.
E629 File switching by code reader has failed.
TRIGGER IN turned off before the minimum
E630
number of scans was reached.
Description
ME-LPGS-SR-5
Measures *1
Check the connection of the cable and various signal
lines, and then restart the laser marker.
• Input this to TIMING IN terminal within 60 seconds
after the I/O connector timing waiting output
(TIMING WAIT OUT) is turned ON.
• Check the connection of TIMING IN terminal of I/
O connector.
• Check the connection with the external device.
• Check the control procedure of the external
control.
• Check the status of connection with the laser
marker and the Ethernet ports of external devices.
• Check the status of the laser marker and external
devices in link control.
• Set the barcode/2D code object for the checking
at the object number 0.
• Confirm the code type and settings of barcode/2D
code object are applicable to the current code
reader configuration.
• Check the status of external devices.
• Improve the marking quality of the code.
• To send the marking strings or to switch the files
by using code reader, confirm the followings:
• Confirm no unavailable characters are in the
code data.
• When using the data extraction function,
confirm the data length in the code data
matches the extraction settings.
• When you do not use the data extraction
function, set the code data less than 299
digits.
• Confirm the specified file number or name exactly
corresponded to the settings in the laser marker.
• To switch the file by the number, specify the
number always with 4-digits in the code data.
• If no settings in the specified file, set the marking
data and save that file to the laser marker.
• Confirm the on/off control of the TRIGGER IN on
the I/O terminal.
• If TRIGGER IN turns on/off properly, change the
setting value of Minimum number of scans of
Trigger mode in File settings.
175