Filter Function; Filter - Filter - Yamaha A3000 Owner's Manual

FILTER Function

FILTER - Filter

Selects the filter type, and sets the cutoff frequency and the Q/width value.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 5 EDIT Mode
182
FILTER Function
You use this function to set the sample's filter type, filter characteristics, and equaliza-
tion. You can also set the way that filter strength varies with respect to velocity and
keyboard location.
FYI
• You can use filter-EG settings and LFO settings to create variations in filter cutoff
frequency over time. ( 192, 202)
• The COMMAND key gives you rapid access to a number of helpful commands while
you are working with this function. For example, you can use the COMMAND key
when you want to save your edit results to disk, or when you want to cancel your new
changes and restore the previously saved data. ( 147)
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
This page sets the filter type, cutoff frequency, and Q/width value.
Change Page
• Turn the knob to change to a different page within the FILTER function. Available
pages are: Filter (this page), FltSens, FltScale, and EQ.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Type
Select any one of the following filter types.
Bypass
LowPass1
CONTROL
MIDI / CTRL
Turn Knob 1 to select Filter.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= Bypass,...,BandElim
No filter.
Low-pass filter #1. (A low-pass filter blocks out all frequencies
above the cutoff frequency.)
Knob 4 Knob 5
- -
Select P/S