Trim/Loop - Loop (Edit Loop Addresses) - Yamaha A3000 Owner's Manual

TRIM/LOOP Function

TRIM/LOOP - Loop (Edit Loop Addresses)

Sets loop start and loop end addresses.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 5 EDIT Mode
166
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to select the start and end points for the playback loop.
FYI
• To set the loop mode (loop direction and type), use the WvMode page. ( 168)
• You can use the EndType setting on the Configure page to select the method for
displaying the end address. ( 161)
Change Page
• Turn the knob to change to a different page within the TRIM/LOOP function. Avail-
able pages are: Config, Wave, Loop (this page), and WvMode.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
LpStart
= loop start address ,..., end address
• Sets the start point of the loop on the waveform. The concept is illustrated below.
• Note that actual loop handling depends on the loop-mode setting. ( 168)
CONTROL
MIDI / CTRL
Turn Knob 1 to select Loop.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
Start Address
Playback Area of Waveform
Looping Area
Loop Start Address
Knob 4 Knob 5
Select P/S
Realtime Set
End Address
Loop End Address