Smpdump (Sample Dump) - Yamaha A3000 Owner's Manual

COMMAND Pages

SMPDUMP (Sample Dump)

Transmits a bulk dump of the selected sample.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knobs 2, 3
Knob 5
Chapter 4 PLAY Mode
108
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to dump a memory-resident sample or sample bank to an external MIDI
device. The dump operation transmits all of the sample's data (or parameter data only;
see below) to the external device.
Important
Before you can transmit or receive a sample dump, you must set matching device-number
values at the A3000 and the external device. ( 310)
Change Page
• Turn the knob to change to a different command page.
• Push the knob to execute the sample dump. The A3000 returns a confirmation screen.
Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
Sample
• Turn either knob to select the sample or sample bank that you want to dump.
• If you select a sample bank: a [B] appears before the sample-bank name, and the
operation name above Knob 5 changes from Format to withRelated.
• Format
• withRelated
The selection here varies according to whether you are dumping a sample or a sample
bank.
• If you are dumping a sample, use the Format setting to select the dump format. Avail-
able formats are as follows.
norm
param
CONTROL
MIDI / CTRL
Press the COMMAND key, then turn Knob 1 to select >SMPDUMP.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= sample name
= norm, param, SDS#1,...,#1025
= off,on
Transmit all data (wave and parameter) in A3000 format.
Transmit parameter data only, in A3000 format.
Knob 4 Knob 5
-
- -
>SMPDUMP