GE DMS Go Operator's Manual page 97

3.1 Creating a Data File (DR - EXPLORER - NEW) (cont.)
Reading Type
Start Point
End Point
File Name
Linear File
Units
T-MIN
T-MAX
DMS Go Operator's Manual
Your Complete Source for
Testing Equipment. Since 1969!
Table 3: Items to be Defined for Each File Type
Set file style to Standard (normally recommended) or Extended.
Defines the number assigned to the first point in the data file.
Defines the number assigned to the last point in the data file.
16 character file name, set using the virtual keyboard. No two files in the DMS Go memory
may have the same file name.
Selects either inches or millimeters as the unit of measurement
Defines the minimum thickness limit. Measurements below this limit cause an alarm to signal.
Defines the maximum thickness limit. Measurements above this limit cause an alarm to signal.
www.BergEng.com
Berg Engineering & Sales Company, Inc.
Chapter 3. Creating Data Recorder Files
1-847-577-3980
Info@BergEng.com
69