Assigning Addresses Automatically - Siemens Synco 700 Series Basic Documentation

Device Name
Procedure
Note
Building Technologies
HVAC Products
A device name can be assigned to each device at the same time as the device
address.
• Enter the device address and/or device name and confirm by clicking
Write
the button (see steps 1 to 4 above).
5.2.2

Assigning addresses automatically

Addresses can be assigned automatically to devices in the address list which are
highlighted in red because of an address problem or conflict. Possible causes:
• The device still has the factory-set device address 255
• The device address is already being used by another device (duplicate
addressing)
1. In ACS Service select Plant > Edit device list... to open the "Edit device list" dialog
box.
2. Under "Highlight devices with" click the
only accessible if at least one device is highlighted in red.
3. Click the address problem
"Address assignment". Click the button
available unused device address.
4. After successful assignment of the address, the device list is refreshed
automatically.
5. Check the "Device name", "Network address" and "State" columns to ensure
that all devices have a valid address and a status of OK.
When addresses are assigned automatically by the service tool, the next unused
device address is assigned, in descending order from 254 (address 254 is used by
the OCI700 service interface).
Basic documentation: Communication via the KNX bus
Device addresses via ACS
address problem
button to enable the button
Automatically
button. This button is
Automatically under
to assign the highest
CE1P3127en
30.08.2007
39/120