Number Of Bus Devices Per Line, Area And Network; Bus Load Number E - Siemens Synco 700 Series Basic Documentation

64 bus devices
on one line
Notes
960 bus devices
in one area
Note
16,320 bus devices
in a network
Main lines 1...15
Area line 0
Notional Line 2
Data traffic of a device
18/120
Building Technologies
HVAC Products
2.1.2

Number of bus devices per line, area and network

Up to 64 bus devices can be installed on one line (including a main line and area
line 0). There are no restrictions relating to the type mix.
The Synco 700 type RMZ78x expansion modules, the RMZ790 and RMZ791
operator units and the room units connected (via PPS2) to the RXB/RXL room
controllers do not have a KNX interface and can be omitted from the design total.
In installations incorporating Synco bus devices (plus the OCI700.1 service tool, if
connected) and third-party devices, the number of Synco bus devices is reduced in
accordance with the number of third-party devices.
Based on 64 bus devices per line and 15 lines per area, up to 960 bus devices can
be installed in an area. The network addresses for Area 1 are:
• Area coupler
1.0.0
• Line coupler
1.1.0...1.15.0
• Bus devices
1.1.1...1.15.254
With KNX TP1 only 64 bus devices are permitted in device address range 1...254.
Theoretically, a total of 16,320 bus devices could be installed in a full KNX TP1
(wired) network. In practice the number is approximately 12,000 bus devices.
Based on 960 bus devices per area, and a full-scale network comprising 15 areas,
up to 14,400 bus devices can be installed in one network.
64 bus devices can be connected to each of the 15 main lines, giving a further 960
bus devices in addition to the 14,400 calculated above, which makes a total of
15,360 bus devices.
Another 64 bus devices can be installed in each of the 15 lines branching off from
area line 0, now giving a total of 15,260 bus devices. Normally, however, no line
couplers are installed in area line 0.
Note: The preset addresses, area address 0 and line address 2 relate to a
"notional line 2" branching from area line 0. The network addresses for this line are
0.2.1 to 0.2.254.
The term "notional line 2" indicates that there is no need to install a line coupler
0.2.0. See the illustration in section 1.3, Full-scale KNX network.
2.1.3

Bus load number E

The bus load number E (short, E-number) applies to the average data traffic of a
device on the bus.
The bus load number does not have to be calculated for a line containing the
permitted 64 bus devices (the total of bus load number is less than 300).
The bus load number E of a device is specified in the relevant data sheet.
Basic documentation: Communication via the KNX bus
Engineering notes
CE1P3127en
30.08.2007