Siemens LMV5 Series Basic Documentation page 229

Error Diagnostic Device
code code
AB 33 O2M
AB 34 O2M
AB 38 O2M
AB 3E O2M
AB 3F O2M
B0 # BU
B0 01 BU
Siemens Building Technologies Basic Documentation LMV51...
HVAC Products 15 Addendum 1: List of fault status messages of LMV51... system
Display
Internal Fault O2 Module Page disrupted
Internal Fault O2 Module Invalid access to parameters
Internal Fault O2 Module Fault during copying of a parameter page Reset the unit.
Internal Fault O2 Module External plausibility fault.
This type of fault covers possible faults
occurring due to invalid presettings in the
drive commands. In response, the
presettings will be ignored
Internal Fault O2 Module Internal plausibility fault.
This type of fault covers possible errors
that cannot practically occur
Fault during test of port outputs
Internal Fault Basic Unit Fault when resetting the set outputs
Meaning for the LMV5x system Troubleshooting
Reset the unit.
! Caution ! If fault occurred during parameterization: Check
the parameters changed last.
If fault cannot be rectified by the reset: Restore AZL5...
parameters.
Otherwise, replace defective O2 module
Reset the unit.
! Caution ! If fault occurred during parameterization: Check
the parameters changed last.
If fault cannot be rectified by the reset: Restore AZL5...
parameters.
Otherwise, replace defective O2 module
! Caution ! If fault occurred during parameterization: Check
the parameters changed last.
If fault cannot be rectified by the reset: Restore AZL5...
parameters.
Otherwise, replace defective O2 module
Reset the unit.
! Caution ! If this fault occurred during parameterization:
Check the parameters changed last.
If fault cannot be rectified by the reset: Restore AZL5...
parameters.
Otherwise, replace defective O2 module
*2)
*1)
229/278
CC1P7550en
01.10.2003