Siemens LMV5 Series Basic Documentation page 189

Loads on terminals
General data
Mains supply
Undervoltage
Oil pump / magnetic clutch
APS test valve
Status inputs (CFN)
Load on terminals
«outputs»
Total load on contacts
Siemens Building Technologies
HVAC Products
13.2 Loads on terminals, cable lengths and cross-
sectional areas
• Max. perm. mains primary fuse (external)
• Unit fuse F1 (internal)
• The mains input current depends on the status of the unit
• Safety shutdown from operating position at mains voltage
• Restart on increase of mains voltage
• Nominal voltage
• Nominal current
• Power factor
• Nominal voltage
• Nominal current
• Power factor
Status inputs (with the exception of the safety loop) of the contact feedback network
(CFN) are used for system supervision and require a mains-related input voltage.
• Input safety loop
• Input currents and input voltages
UeMax
−
UeMin
−
IeMax
−
IeMin
−
• Recommended contact material for external
signal sources (APS, PSmin, PSmax, etc.)
• Transition / transient behavior / bouncing
Max. perm. bounce time of contacts
−
when switching on / off
(after the bounce time, the contact must be permanently closed or open)
• UN
• Voltage detection
ON
−
OFF
−
• Nominal voltage
• Unit input current* (safety loop)
* Total contact current resulting from:
Fan motor contactor
-
Ignition transformer
-
Valves
-
Oil pump / magnetic clutch
-
Basic Documentation LMV51...
13 Technical data
6.3 AT (DIN EN 60 127 2 / 5)
AC 230 V +10 % / -15 %, 50-60 Hz
AC 230 V +10 % / -15 %, 50-60 Hz
refer to «Loads on terminals, outputs»
gold-plated silver contacts
AC 180...253 V
AC 230 V +10 % / -15 %, 50-60 Hz
16 AT
< AC 186 V
> AC 188 V
2 A
cosϕ > 0.4
0.5 A
cosϕ > 0.4
UN +10 %
UN -15 %
1.5 mA peak
0.7 mA peak
50 ms
AC 230 V
< AC 80 V
max. 5 A
189/278
CC1P7550en
01.10.2003