Siemens DMS8000 MP4.30 Connectivity Manual page 8

6
Building Technologies
Fire Safety & Security Products
The Fig 1 illustrates how to add the VNM to the configuration:
1. In the MM8000 physical configuration, select the main station name:
Supervisor System Settings  MM8000 System  Physical configuration
 <Station name>
In the MK8000 project, the selection is quite similar:
MK8000 System  MK8000  Physical configuration  <Station name>
2. Click the button A to add the VNM (see Fig 1).
A new node is added. No further configuration is required for the VNM.
Fig 1 Adding the Video Network Manager (A)
Note: Adding the VNM results in the entire Composer project being expanded in
order to support the CCTV functions. Particularly, a new Camera Extensor tab is
added to all nodes. Depending on the size of the configuration tree, the operation
may take a few minutes.
The Composer plug-in #251701 is required.
Fig 2 New tab added by the VNM in the MM8000 project
Camera Extensor tab
In the Camera Extensor tab, you can see the camera associations and manually
add one or more cameras to the list associated with the selected node. Also, for
dome and PTZ cameras, you can set the default Preset Position (where the cam-
era is moved when it is first selected during event treatment).
Refer to the point customization section of the MM8000 Installation, Configuration
and Commissioning manual (ICC) for more information about the Camera Exten-
sor tab.
048_DMS_DMS8000_Connectivity_Video_MP4.30_A6V10062457_a_en.doc
Configuring CCTV network
06.2010