Siemens DMS8000 MP4.30 Connectivity Manual page 18

Simatrix, telscan, sistore burle/philips ltc8000 light-integration device (external viewer)

Hide thumbs Also See for DMS8000 MP4.30:

Table of Contents

Building Technologies

Fire Safety & Security Products

– IP address, which should match the value set in the TELSCAN (see

TELSCAN documentation).

Note: The button Set Default Value can be used to reset any change in the

IP address field and go back to the factory setting.

– Fault diagnostic fields: Ping frequency (default 10 sec) and Retry times

(default 3 times).

– User Name and Password as required to access the IP device (refer to the

device's local configuration).

3. For MM8000 (this step is not required for MK8000), once the correct IP address

is set, press the button Send HTML files.

 This results in a specialised HTML page being downloaded into the

TELSCAN via FTP (File Transfer Protocol) service. The page is required for the

interface to operate properly with the TELSCAN.

Failing in loading this page at least once causes defective displaying of the video

camera pages.

Fig 10

TELSCAN settings

Connecting the TELSCAN/IP Camera to Video Driver

1. Select the TELSCAN/IP camera node.

2. Select the TELSCAN Video Driver (see 2.2.1 at p.7).

3. Drag and drop the TELSCAN/IP camera to the driver (Fig 11).

048_DMS_DMS8000_Connectivity_Video_MP4.30_A6V10062457_a_en.doc

Configuring CCTV network

06.2010

Table of Contents