Monitor Configuration; Configuration Checklist; Configuration Procedure - Siemens DMS8000 MP4.30 Connectivity Manual

Configuring CCTV network
2.5

Monitor configuration

2.5.1

Configuration checklist




2.5.2

Configuration procedure

Building Technologies
Fire Safety & Security Products
Verify that you have satisfied the items needed in the first checklist before proceed-
ing to the configuration procedure that follows.
ITEMS NEEDED FOR CONFIGURATION
The number and type of monitors: Monochrome or colour
The connection to SIMATRIX and SISTORE units
Plug-ins needed:
Plug-in #352901, which must be installed before you can configure your system
–
The following are the configuration procedures for the video monitors.
Adding the Video Network Manager
1. Open the Composer project.
2. If not already done, add the Video Network Manager ( 2.2 at p.5).
Adding the folder for monitors
1. In the left-hand bar, select the Video folder icon
2. In the menu that appears, select the Video Monitor folder icon
folder
( Fig 4 at p.8).
Adding a monitor
1. Select the Video Monitors folder.
2. In the left-hand bar (Fig 9), select the type: Monochrome or Colour Monitor.
Also, in the same menu, you can add additional folders that let you better or-
ganise the monitor according to type, location, etc.
Fig 9 Adding monitors
A Select this icon to add a colour monitor
B Select this icon to add an additional folder
C Select this icon to add a monochrome monitor
048_DMS_DMS8000_Connectivity_Video_MP4.30_A6V10062457_a_en.doc
to add a
13
06.2010