Figure 43: Base Radio – HPD Backplane
Table 37: Base Radio Backplane Connections for HPD
Port /
Device it connects to:
Type
SC A port,
Site Controller module A
RJ-45
SC B port,
Site Controller module B
RJ-45
RX-A,
Receive line A
BNC
RX-B,
Receive line B
BNC
Transmit
Transmit line
port, N-
type
Aux Pwr
Site Controller or
Output
RMC/LNA
Bat Temp,
Battery temperature sen-
6-pin
sor
Chapter 3: GTR 8000 Base Radio Installation
Port /
Type
Base ra-
Connects to site controller A base radio
dio port,
port for this channel.
RJ-45
NOTICE: The length of the cable
between the site controller and
the base radio should be no
greater than 30 feet.
Base ra-
Connects to site controller B base radio
dio port,
port for this channel.
RJ-45
BNC
RF coax to receive path for Rx antenna.
BNC
RF coax to receive path for antenna B.
N-type
RF coax to transmit antenna.
Aux Pwr
The auxiliary output power can be used to
Input
provide secondary power to the site con-
troller or receive multicouplers (Site RMCs/
LNAs).
Connection to temperature sensor, allow-
ing for temperature compensated battery
charging.
MN003286A01-E
Description
109