Acs800-11/U11 Specific Parameters In The Igbt Supply Control Program; Terms And Abbreviations; Parameters; System Ctr Inputs - ABB ACS800 Series Hardware Manual

ACS800-11/U11 specific parameters in the IGBT Supply Control Program

The signals and parameters of the IGBT Supply Control Program which are specific
to the ACS800-11 and ACS800-U11 are described in the tables below. These
parameters need not be set in a normal start-up. For more information on
parameters of the IGBT Supply Control Program, refer to ACS800 IGBT Supply
Control Program Firmware Manual [3AFE68315735 (English)].

Terms and abbreviations

Term
B
C
Def.
FbEq
I
R
T.

Parameters

No. Name/Value
16 SYSTEM CTR
INPUTS
16.15 START MODE
LEVEL
EDGE
Definition
Boolean data type
Character string data type
Default value data type
Fieldbus equivalent: the scaling between the value shown on the control
panel and the integer used in serial communication
Integer data type
Real data type
Data type (see B, C, I, R)
Description
Parameter lock, parameter back-up etc.
Selects I/O control start mode when par. 98.01 COMMAND SEL is
set to I/O.
Starts converter by level of control command. Control command is
selected by parameter 98.01 COMMAND SEL and 98.02 COMM.
MODULE.
WARNING! After a fault reset, the converter will start if the
start signal is on.
Starts converter by EDGE of control command. Control command is
selected by parameter 98.01 COMMAND SEL and 98.02 COMM.
MODULE.
T./FbEq Def.
B EDGE
0
1
Actual signals and parameters
105