Connecting The Control Cables; Terminals - ABB ACS800 Series Hardware Manual
Hide thumbs
Also See for ACS800 Series:
- Firmware manual (340 pages) ,
- Hardware manual (210 pages) ,
- Cabinet installation and operating instruction (162 pages)
Table of Contents
Advertisement
78
Connecting the control cables
Lead the cable through the control cable entry (1).
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board [refer to chapter
and I/O board
Terminals
Control panel
Optional module 1
Control cable
grounding: see
section
360
degrees
grounding
Electrical installation
(RMIO)]. Tighten the screws to secure the connection.
1
View of frame size R6
Optional module 2
DDCS communication module: RDCO
Channel CH1 is used for the internal communication
between the line-side and motor-side converters.
Detachable connection terminals (pull up)
Motor control
Hide quick links:
Advertisement
Table of Contents
