Initial Commissioning; Unpacking; Installation - Bosch TCE 4540 Original Instructions Manual

4.

Initial commissioning

4.1

Unpacking

1. Remove the tape and the fixing clamps from the
pallet and the packaging cardboard.
i
After unpacking check the integrity of TCE 4540 and
check that no components are visibly damaged. In
case of doubt do not proceed to start-up and con-
tact a qualified technician and/or your vendor.
2. Take out of the transport crate the standard accesso-
ries and the packaging materials.
i
Dispose correctly of packaging material, hand it over
to the designated collection points.
4.2

Installation

1. Loosen the four screws that fix TCE 4540 to the
pallet.
Warning - damage risk!
The lifting belts can crush the flexible supply
pipes of the cylinder or damage the applied
parts of the TCE 4540.
€
Insert the lifting belts carefully.
Robert Bosch GmbH
Initial commissioning | TCE 4540 | 31
2. Insert the appropriate lifting belts (length belt 1: 1
mt, belt 2: 3 em, with sufficient capacity, as shown.
1
Warning - tilting danger!
The barycentre of the TCE 4540 is not at its
centre.
€
It is essential to lift the machine slowly.
en
2
|
1 695 105 790 2010-05-04