Mounted Wheel Removal - Bosch TCE 4540 Original Instructions Manual

Fig. 10: Infl ation with tire infl ater and tire quick infl ation device.
8. Once tire bead is seated in the rim, proceed with
inflation by bringing the tire inflation pedal in central
position and holding this position until nominal pres-
sure is reached for the correspondent tire type.
i
If the pressure is too high it is possible to lower it
with the button beside to the manometer.
Robert Bosch GmbH
5.4

Mounted wheel removal

!
Place no object in the area of the wheel supporting
bracket!
1. To release the rim from the locking flange unscrew
the tightening pin, remove the tightening ring nut
and the centring cone.
2. Place the centring cone, the tightening ring nut and
pin in the object compartment.
3. Lift the wheel by means of the wheel lifting pedal.
4. Push the wheel from the roller base to the wheel hol-
ding bracket.
5. Operate the wheel lifter pedal to put the wheel
down on the floor.
6. Remove the wheel.
Use | TCE 4540 | 43 en
|
1 695 105 790 2010-05-04