Mounting Of Non Critical Rim/Tire Combinations - Bosch TCE 4540 Original Instructions Manual

2. Lubricate the side of the tire (RFT/UHP) and the tire
bead (inside/outside) with the mounting paste (as
shown in the picture).
3. Put the tire sideways on the rim.
Robert Bosch GmbH
5.2.2

Mounting of non critical rim/tire combinations

i
In case of non critical wheels for bead fitting only
the mounting tool and the the tightening flange are
used.
Warning – hand injury danger!
Risk of crush injuries during tightening flange
rotation.
€
Do not insert the fingers between the tire
and the rim.
1. Position the flat part of the tool on the edge of the
rim by means of the central button (AUTO) of the
hydraulic control unit. Rotate the tightening flange
stepping on its pedal, being careful that the bead
does not enter into the lowered well of the rim, in
order to eliminate yielding of the bead.
i
Be sure that the lower tire bead slides in the semi
drop centre passing close to the edge of the rim. To
make this operation easier it is advisable to assist
it by exerting with the hands a light pressure on the
tire.
2. In case of tires with tube bring the valve of the tire in
position hour 3 and insert a new tube.
Use | TCE 4540 | 39 en
|
1 695 105 790 2010-05-04