Table of Contents
Advertisement
18
en | Setup tasks
4.5.2
Front panel LED behavior
The table below describes LED behavior when boot-up is finished and the system is operating
normally:
LED
Power
System status
Global RAID status
Global HDD activity
System heartbeat
OPAS USB
4.5.3
Disk drive LEDs
Figure 4.13: Hard disk drive carrier LEDs
There are two LEDs on each drive carrier. They report activity of the drive, and current
condition of the drive.
LED
Disk status
Disk activity
4.5.4
PSU LEDs
After powering on the subsystem, check the LEDs on each power supply on the rear of the
device.
2019-10 | V01 | F.01U.380.028
Description
Blue - System is powered on.
Green - System is normal.
Red - System trouble. Such as LD offline, fan malfunction, voltage
out of range, system temperature alert.
Red flash - HDD high temperature alert
Off steady - System is not ready.
Green - Status is normal.
Red - RAID volume is offline.
Orange - Critical state of any logical drive, or system is rebuilding.
Blue flash - One or more drives are being accessed.
Blue - No drives are being accessed.
Blue flash - Firmware and software are operating normally.
Green - OPAS device (USB disk) is detected.
Green flash - OPAS operation is in progress.
Red - OPAS operation has failed.
Description
Green - HDD is configured and working properly.
Red - HDD requires manual replacement.
Orange - Status notification of background RAID activity on this
articular HDD, and no user action is required.
Blue flash - During drive activity.
Quick installation guide
CIP5000 series storage
Drive Status (OK)
Activity
Bosch Security Systems B.V.
Advertisement
Table of Contents
