CIP5000 series storage
Caution!
Do not load the rails unless they are installed with screws as instructed.
!
Caution!
The rails available for the CIP enclosure hardware are designed to safely support that CIP
!
enclosure hardware when properly installed. Additional loading on the rails is at the
customer's risk.
Caution!
Bosch cannot guarantee that the mounting rails will support your CIP enclosure hardware
!
unless you install them as instructed.
Install the enclosure to the rack using the optional rails.
Notice!
To lighten the enclosure, you can remove the power supplies. Replace the power supplies
after the unit is mounted on the rack.
Support flange on the
front end of each rail
Figure 4.1: Installing the rails onto the rack
Bosch Security Systems B.V.
Front left label
Quick installation guide
Front right label
Guide pins on rails align with
holes in the rack post
Setup tasks | en
11
2019-10 | V01 | F.01U.380.028