Installing Option Modules; Mounting Locations Of Option Modules - Siemens SIPROCESS GA700 Operating Instructions Manual

Installing / removing and connecting analyzer and option modules

7.7 Installing option modules

3. Remove the following cables:
– Power cable to the analyzer module printed circuit board and power supply unit
– 12-pin ribbon cable (CAN) to the analyzer module printed circuit board and the
– If applicable, 26-pin ribbon cable to the analyzer module PCB or the AO adapter card
4. Loosen the eight Torx screws on the base of the enclosure
on the rear wall.
5. Swivel the analyzer module
6. If you are not installing and connecting a new analyzer module:
Fasten the blank plate over the respective slot using the eight Torx screws
torque of 0.8 Nm.
7. Close the door of the enclosure with the six screws
Tighten the screws
7.7 Installing option modules
Note
Enable analog and digital outputs
If you subsequently install an option module 2.1, you must enable the analog and digital
outputs using SIMATIC PDM after restarting:
1. Establish a connection between SIMATIC PDM and the analyzer.
You may have to log on at the Expert level.
2. Navigate to: Parameter group overview > Properties > Device
3. For the "Option module 2.1" parameter, set the value "Yes".
4. Transfer the modified parameter assignment to the device.
7.7.1

Mounting locations of option modules

Features
You can find information on option module features with inputs and outputs in the section
"Technical specifications (Page 141)".
Mounting locations
The wall enclosure has been prepared for the installation of up two option modules.
68
processing unit
and the option module OM 2.1 or OM 2.2
②
on the door with a torque of 3.5 Nm.
⑥
forward and remove it from the wall enclosure .
Operating Instructions, 05/2018, A5E31930403-06
⑤
and the two Torx screws
②
.
Wall-mounted device
⑤
with a