Downloading Texts To The Dus 1728 / 1735 / 1736 And Ext. Fbps 1826 / 1828; Real Time Clock (Rtc) - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
13.22.2
13.23
has to be typed in the EBLWin "Text editor", for the "display unit"
respectively (Properties | Edit texts...):
Explanations (Text editor for one specific "display unit"):
Zone-Address column
Shows the already programmed alarm points (e.g. 001-01, 001-02,
002-01 etc.).
Shows the already programmed zones, i.e. MIO unit 3361 zone line
inputs and 8 zones expansion board 4580 zone line inputs
programmed with address "00" (i.e. as ZZ – 00).
Text in control unit column (only information that cannot be edited)
Shows the already programmed texts for each alarm point / zone.
These texts will be displayed in the control unit and all "display units"
1826, 1828, 1735, 1736 and 1728 if there are no other texts
programmed.
Text column
The text to be shown in this "display unit" for the alarm point / zone
respectively, has to be typed (edited) here. In this "display unit" the
text in the "Text" column will now be shown instead of the text in the
"Text in control unit" column, for the alarm point / zone respectively.
Downloading texts to the DUs 1728 / 1735 / 1736 and
ext. FBPs 1826 / 1828
The "display units" have to be connected to EBL128 and the address
117
and mode have to be set in the "display units".
The texts will then be downloaded at the same time as the EBL128
site specific data (SSD) is downloaded via EBLWin.
Alt. via the DU pop-up menu in EBLWin.

Real time clock (RTC)

EBL128 has a built-in RTC that is used for date and time presentation
in conjunction with fire alarms, faults, log events, etc. It also controls
the time channels 2-14. The RTC has no backup battery, i.e. the date,
time, etc. has to be set (via menu H3) after total loss of power supply
(i.e. no mains and no backup battery) and .after S/W download.
117 S/W mode xxxx – 1587. (xxxx = e.g. 1826/28)
118
In the "Download SSD to Control Unit" dialog box the "Download
display units" check box has to be selected.
114
EBL128 Planning Instructions V2.0.x
118