Siemens SINUMERIK 840 User Manual page 204

7 Measuring in JOG Mode (SINUMERIK 880/880 GA2)
7.1.1 Operating and function sequence
If a value other than "0" is entered the contents of the chosen empirical value memory are
displayed. This value is taken into account when the tool geometry is calculated. The empirical
values must be entered/stored in the cycle setting data.
The number of empirical value memories depends on
(See information supplied by the machine tool
Measurement parameter
If a tool type 1 ... 9 is entered the tool geometry is calculated using the defined plane and the
selected traversing axis, i.e. any entries in the input display at this point are of no significance.
If a tool type 10 ...39 is entered, the geometrical value which is to be used (radius, length L1
or L2) must be entered under measurement parameter.
Input "0" Measure radius
"1" Measure length L1
"2" Measure length L2
4. You position the tool near the tool probe by operating the JOG direction
X
keys.
Z
X Measuring axis X
Operator moves tool to be
measured towards the
probe
Operator
operates direction
of movement
M
Tool measurement in JOG mode
7–4
the machine configuration.
manufacturer).
(0 - 2)
S
P
Probe
(calibrating)
©
Siemens AG 1990 All Rights Reserved
F
X
PF
S
P
Z
PF
6FC5197- AB70
SINUMERIK 840/850/880 (BN)
01.93
Z