Adjusting The Picture Quality; Using The Black Stretch Feature; Using Mpeg Noise Reduction - Toshiba 26HLC56 Owner's Manual

Adjusting the picture quality

You can adjust the picture quality (back light, contrast,
brightness, color, tint, and sharpness) to your personal
preferences.
Pressing C
Selection
Back Light darker
Contrast lower
Brightness darker
Color paler
Tint reddish
Sharpness softer
To adjust the picture quality:
1
Press Y and open the Picture menu.
2
Highlight Picture Settings and press T.
3
Press B or b to select the picture quality you want to
adjust (Back Light, Contrast, Brightness, Color,
Tint, or Sharpness), and then press C or c to adjust the
setting, as described in the table above.
Picture Settings
Back Light
Contrast
Brightness
Color
Tint
Sharpness
MENU Back EXIT
Contrast
The picture qualities you adjusted are automatically saved in
the Preference mode (- "Selecting the picture mode" on
the previous page).
Note:
• The cold cathode fluorescent lamp used for the back light
on this monitor has a limited life. When areas on the screen
darken, flicker, or no longer light up, the lamp may be at the
end of its life.
• When the monitor is in VIDEO mode or when no signal is
received, the back light feature is automatically set to "0"
(zero).
30
Chapter 6: Using the Monitor's features
Pressing c
lighter
higher
lighter
deeper
greenish
sharper
1/2
100
100
50
50
0
0
Watch TV
80

Using the black stretch feature

You can use the black stretch feature to correct the contrast
balance in the black areas of the picture. The effect depends on
the quality of the video signal.
To turn on the black stretch feature:
1
Press Y and open the Picture menu.
2
Highlight Picture Settings and press T.
3
Press B or b to highlight Black Stretch.
Picture Settings
Black Strech
MPEG NR
CableClear DNR
Color Temperature
MENU Back EXIT
4
Press C or c to select On.
Black Strech
To turn off the black stretch feature:
Select Off in step 4 above.

Using MPEG noise reduction

The MPEG noise reduction feature allows you to reduce
visible interference caused by MPEG compression. Choices
for MPEG noise reduction are
is automatically selected when this feature is disabled
Off
("grayed out").
To select the MPEG noise reduction level:
1
Press Y and open the
Picture
2
Highlight
Picture Settings
3
Press B or b to highlight MPEG NR.
Picture Settings
Black Strech
MPEG NR
CableClear DNR
Color Temperature
MENU Back EXIT
4
Press C or c to select Low, Middle, High, or Off.
MPEG NR
2/2
Off
Low
Auto
Medium
Watch TV
On
, , , and .
Off Low Middle High
menu.
and press T.
2/2
On
Low
Auto
Medium
Watch TV
Middle