Trimming The Pipes - Siemens FDA241 Planning, Mounting

Asd pipe system

Hide thumbs Also See for FDA241:

Table of Contents

5.2.1 Trimming the pipes

Building Technologies

Fire Safety

NOTICE

Swarf and dust in the pipe system

Influence on the detection features of the aspirating smoke detector

Only use a pipe cutter to trim the pipes.

Do not use saws or other cutting tools.

Purge the pipes of swarf or impurities by blowing them out.

Planning of the pipe system is complete.

The length of the pipes is defined.

A pipe cutter is available to trim the pipes.

1. Trim the pipes to the desired length using the pipe cutter.

–

Make the cut at a right angle to the pipe's longitudinal axis.

2. If necessary: Deburr the interface with a file and remove the swarf produced.

The pipes are ready for installation.

Figure 15: Right-angled cut when trimming pipes

Table of Contents

Fda221