Shutdown; Disassembly And Replacement; Preparing The Product For Storage/Further Use - Bosch Rexroth LU 2 Assembly Instructions Manual

12 Shutdown

The product is a component that does not need to be taken out of service.
Therefore, the chapter in these instructions contains no information on the topic.

13 Disassembly and replacement

High electrical voltage!
Risk of serious injury or death from electric shock.
Disconnect the relevant system component before you perform maintenance
and repair work.
Secure the system against being switched on unintentionally.
High pneumatic pressure!
Risk of serious injury or death.
Switch off the compressed air supply on the relevant system component
before performing any maintenance or repair work.
Secure the system against being switched on unintentionally.
Lifted loads may fall.
Falling objects can result in serious injury (or even death).
Always use lifting equipment with suffi cient load bearing capacity
(see shipping documents for product weight).
Check if the carrying straps are attached properly before lifting the product.
The product must always be prevented from tipping over when lifting.
During raising and lowering pay attention that nobody other than the operator
is in the danger zone.

13.1 Preparing the product for storage/further use

• Only store the product on a fl at surface.
• Protect the product from mechanical stress.
• Protect the product from environmental infl uences such as dirt and moisture.
• Pay attention to the ambient conditions, see page 53.
• For products with mounted motor, support the product so that hanging-mounted
engines will not be burdened.
WARNING
3 842 358 814/2017-01, MIT: LU 2, Bosch Rexroth AG
Shutdown 49/54