Short Description Commissioning; Re-Commissioning After A Standstill Period - Bosch Rexroth LU 2 Assembly Instructions Manual

Automatic lubrication unit

Hide thumbs

Table Of Contents

Table of Contents

42/54

Start-up

Bosch Rexroth AG, MIT: LU 2, 3 842 358 814/2017-01

• Before initial commissioning ensure that there are no protruding or sharp-edged

parts that may endanger personnel working or moving in the area.

• According to EU Machinery Directive 2006/42/EC, you must equip the transfer

system with EMERGENCY STOP devices.

• The surfaces of engines and gearboxes can reach temperatures of over 65 °C under

certain load and operating conditions. In these cases, you must comply with the

appropriate design measures (protective measures) or the corresponding warnings

of the applicable accident prevention regulations (UVV)!

• Make sure that all electrical connections are either used or covered. Make sure that

all screw and plug-in connections are properly seated.

All relevant protective covers must be installed.

• Continuous conveyors which are in motion or in operation may only be inspected

and adjusted once all required safeguards are in place.

• Note EN ISO 13857 when you remove or replace safeguards and/or nullify a safety

guideline.

• Test runs with open panels are only allowed if they are carried out by a competent

person using tip switches and no interference through other switching elements exists.

• Only start up the product if all safety devices have been installed in the system

and are functional.

• Start up the product only if it is installed completely.

9.1.1