Siemens SINUMERIK 840D sl Programming Manual page 528

Appendix
A.1 Overview of measuring cycle parameters
Channel-specific values (for measuring in JOG, from measuring cycles SW6.3, GUD7_MC)
Block Identifier
GUD7 E_MESS_FM
GUD7 E_MESS_F
GUD7 E_MESS_FZ
GUD7 E_MESS_CAL_D
(from measuring cycles
SW 6.3)
GUD7 E_MESS_CAL_L
(from measuring cycles
SW 6.3)
GUD7 E_MESS_MAX_V
GUD7 E_MESS_MAX_S
GUD7 E_MESS_MAX_F
GUD7 E_MESS_MIN_F
GUD7 E_MESS_MIN_F_FAK1
GUD7 E_MESS_MIN_F_FAK2
GUD7 E_MESS_MIN_D
GUD7 E_MESS_MS_MONO
GUD7 E_MESS_MS_SOUTH
GUD7 E_MESS_MT_TYP[3]
GUD7 E_MESS_MT_AX[3]
GUD7 E_MESS_MT_DL[3]
GUD7 E_MESS_MT_DR[3]
GUD7 E_MESS_MT_DZ[3]
GUD7 E_MESS_MT_DIR[3]
GUD7 E_MESS_MT_D
GUD7 E_MESS_MT_FM
GUD7 E_MESS_MT_CF
GUD7 E_MESS_MT_COMP
GUD7 E_MESS[3]
GUD7 E_MEAS
GUD7 E_MESS_RETT
GUD7 E_MESS_SETT[10]
A-38
Description
measurement
Measuring feed [mm/rev]
Plane feedrate for collision monitoring [mm/min]
Infeed feedrate for collision monitoring [mm/min]
Diameter, calibration ring
Calibration dimension in the feed axis (referred to WCS) 0
Max. peripheral speed for measuring with rotating
spindle [m/min]
Max. spindle speed for measuring with rotating spindle
[rpm]
Max. feedrate for measuring with rotating spindle
[mm/min]
Min. feed for measuring with rotating spindle for the 1st
probing [mm/min]
On tool measurement with rotating spindle, traversal
with 10 times measuring feed is performed in the 1st
probing (limitation by E_MESS_MAX_F) [mm/min]
For tool measurement with rotating spindle, 2nd probing
is performed with measuring feed. There is no 3rd
probing [mm/min]
Measuring accuracy for measuring with rotating spindle
[mm/min]
Probe is treated as multi probe
Probe is used with reference to the probe sphere end
Type of tool probe
Permissible axis directions for tool probe
Diameter of tool probe for length measurement
1)
Diameter of tool probe for radius measurement
1)
Infeed for measurement tool probe diameter
Approach direction in the plane tool probe
Calibrate measurement path for tool probe and tool
measurement with motionless spindle (before and after
expected switching position)
Calibrate measuring feed for tool probe and tool
measurement with motionless spindle
No tool probe make (manufacturer) specified
No offset of the measurement result on tool
measurement with rotating spindle
Internal data item
Internal data item
Internal data item
Field for settings
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
As-delivered value
300
2000
2000
0
100
1000
20
1
10
0
0.01
0
1
0
133
0
0
2
-1
10
100
0
0
Measuring cycles