Appendix; Overview Of Measuring Cycle Parameters; A.1 Overview Of Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Measuring cycles

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Appendix

Parameter definition

Illustration in the

table (cell)

Measuring cycles

Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0

Parameter must be defined and/or the parameter's definition depends on the

measuring variant, other parameters or the machine configuration.

Parameter is not used in the cycle

Workpiece measurements

Specifying distances and angles

3 measuring points

Only included if calculated larger than internal value

Retraction in

infeed axis,

for overtravel of

corner if _ID=0

travels around

Automatic setup of inside and outside corner

for G17: in XY plane

for G18: in ZX plane

for G19: in YZ plane

4 measuring points

Measurement path in mm

Retraction in

infeed axis,

for overtravel

of corner if

_ID=0 travels

Specifying 4 points

Corner inside

Corner outside

Infeed of positioning depth to

measuring depth (incremental)