Figure 5-70 Ribbon Cable Installed; Figure 5-71 8Lki (Ld)-L Unit Installed - NEC Univerge SV9100 System Hardware Manual

5-70
7. Plug ribbon cable on back of 8LKI (LD)-L UNIT into
connector (metal side down) until pressure is felt.
8. Press down on the black bar to lock the cable into place
(refer to

Figure 5-70 Ribbon Cable Installed

9. Align the projections on the bottom of the 8LKI (LD)-L UNIT
with the guide holes on top of the multiline terminal (refer to
Figure 5-70 Ribbon Cable Installed on page
10. Slide the 8LKI (LD)-L UNIT toward the keypad buttons until
snug (refer to
Figure 5-70 Ribbon Cable
Guide
Guide
Figure 5-71 8LKI (LD)-L UNIT

Figure 5-71 8LKI (LD)-L UNIT Installed

Installing DT Series Digital and IP Multiline Terminals
Issue 3.0
Installed).
Projection
(One Each Side)
5-70).
Installed).