Table 4-39 Gcd-Ccta Led Indications - NEC Univerge SV9100 System Hardware Manual


4-98
The T1 interface has a single 24 channel 64kb/s digital signal circuit which
can be configured either for T1 trunking.
Refer to the following tables for maximum upgrade capacities of the
GCD-CCTA blade:
Table 2-6 SV9100 Maximum 9.5" Gateway and 19" System

Capacities – Blades on page 2-12
Table 2-7 SV9100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-14
6.3.2 Installation
Install the GCD-CCTA in any universal slot.
6.3.3 LED Indications
LED indications for the GCD-CCTA are listed in
Indications. Each LED is listed with its associated function and LED and
Operational status.
Refer to Figure 4-41 GCD-CCTA LED Indication Pattern of Layer 1 on T1
Unit on page 4-99

Table 4-39 GCD-CCTA LED Indications

Alarm Details of the Alarm
LOS Loss of Signal (Red Alarm)
No Signal (Analog Interface)
AIS Alarm Indication Signal
(Blue Alarm)
OOF Out Of Frame (Red Alarm)
RAI Remote Alarm Indication (Yellow
Alarm)
No Alarm The system does the LED control.
The order of priority is set up to alarm in the order LOS
for LED pattern information.
LED Indication Pattern
Following an alarm blink (red,
green, red, green) a Red LED
lights.
Following an alarm blink (red,
green, red, green) a Red LED
slowly flashes On and Off twice.
Following an alarm blink (red,
green, red, green) a Red LED and
Green LED flash On and Off three
times simultaneously.
Following an alarm blink (red,
green, red, green) a Green LED
flashes On and Off twice.
 
AIS OOF
Issue 3.0
Table 4-39 GCD-CCTA LED

RAI.
Installing the SV9100 Blades