Table of Contents
Advertisement
Stainless steel frame/control
panel
Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and
stainless steel cleaning agent. We
recommend using a stainless steel
conditioning agent to help prevent
resoiling (see "Optional accessories").
Do not use a ceramic and stainless
steel cleaner or stainless steel
conditioning agent on the printing.
This would rub the printing off.
These areas should only be cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
Control knob(s)
Clean the control knob(s) using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Stubborn soiling should be
soaked first.
Dry the control knob(s) with a clean
cloth.
Cleaning and care
Stainless steel surfaces
Risk of damage by pointed
objects.
The seal between the cooktop and
the worktop could suffer damage.
Do not use pointed objects for
cleaning.
Damage caused by soiling.
Soiling, particularly salty food or
liquid and olive oil, can cause
damage if left on the printed surfaces
for a long time.
Remove any soiling which comes
into contact with the printed flame
symbols straight away.
Damage caused by incorrect
cleaning.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
Clean stainless steel surfaces using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Stubborn soiling should be
soaked first. If necessary, the rough
side of a non-scouring sponge can
be used.
Finally, dry with a clean soft cloth.
Useful tip: The Miele care product for
stainless steel can be used after
cleaning to help maintain your
appliance in good condition (see
"Optional accessories"). Apply sparingly
with a soft cloth following the
instructions on the packaging.
29
Advertisement
Table of Contents
