Stainless Steel Frame/Control Panel; Control Knobs; Stainless Steel Trough - Miele CS 1028 G Operating And Installation Instructions

Cleaning and care
Stainless steel frame/control
panel
 Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and
stainless steel cleaning agent. We
recommend also using a stainless steel
conditioning agent to help prevent
resoiling (see "Optional accessories).
Do not use ceramic and stainless
steel cleaner or stainless steel
conditioning agent on the printing.
This would rub the printing off.
These areas should be only cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.

Control knobs

 Clean the rotary control(s) using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Soften any stubborn soiling
beforehand.
 Dry the control(s) with a clean cloth.

Stainless steel trough


Risk of damage by pointed
objects.
The seal between the hob and the
worktop could suffer damage.
Do not use pointed objects for
cleaning.
26

Damage caused by soiling.
Soiling, particularly salty food or
liquid and olive oil, can cause
damage if left on the printed surfaces
for a long time.
Remove such soiling immediately.

Damage caused by incorrect
cleaning.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
 Clean stainless steel surfaces using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Soften any stubborn soiling
beforehand. If necessary, the rough
side of a non-scouring sponge can
be used.
 Finally, dry with a clean soft cloth.