Philips M3150B Installation And Service Manual page 220

Network Names and IP Addresses
Step 6. Highlight the TCP/IP in the Protocols window and click on Properties brings up
Step 7. Enter an IP Address for this device using one of the Recommended IP
Step 8. Enter a Default Gateway for this device. Use the factory default value.
Step 9. Click OK to close the Microsoft TCP/IP Properties, OK again to close the
Step 10. Shutdown and Restart the device to return to the Windows Main Menu.
After setting Host Names and IP Addresses, Network Interface Card (NIC)
configurations must also be verified. The following steps give the procedure for verifying
the NIC configuration for the Server.
Step 11. Click on Start, Settings and Control Panel to open the Control Panel.
Step 12. Double click on the Network and Dial-up Connections icon to open the
Step 13. Right click on the Hospital LAN icon and select Properties. The Hospital LAN
Step 14. Click the Configure button. Click on the Advanced tab.
Step 15. Verify the value in the field shown in Figure 5-37.
5-40
Hardware Installation
the Internet Protocol TCP/IP Properties window of Figure 5-34
Addresses for that type of device given in Table 5-1.
Network window, and then close the Control Panel.
Network and Dial-up Connections window.
Properties window shown in Figure 5-35 opens.
Figure 5-37 M3154 Server HLAN Speed/Duplex Setting