Panasonic LP-GS Series Serial Communication Command Manual page 47

⿎ Change the marking characters and start marking
1. Laser pumping (ON)
2. File selection by number
3. Character entry
4. Shutter open
5. Status checking
Marking trigger ready: ON
6. Marking trigger
No: Mark the same
characters
10. Shutter close
11. Laser pumping (OFF)
12. Overwrite file
*1 : From sending the laser pumping on request to completion of laser pumping, the following time will be required.
• LP-GS series: about 8 to 15 seconds
• LP-RC series: about 10 seconds
• LP-RF series: about 7 seconds
• LP-RV series: about 1 second
*2 : Commands from No. 2 to No. 5 above chart can be sent right after turning on laser pumping (without waiting for the
laser pumping completion).
*3 : There is a delay time of around 200ms to max. 1 second from sending shutter open/close command for the actual
shutter open/close operation time.
Besides, with LP-RC series for the first operation of opening shutter after the laser pumping on, it takes around 300ms
to max. 4 seconds.
Remote mode ON
LSR command
FNO command
MCS or STR command
SHT command
STS command
Yes
MRK command
Change the character
to be marked
No: Finish
operation
SHT command
LSR command
FOR command
Remote mode OFF
ME-LP-GS-SR-COMP-3
*1, *2
Transmit the characters you want to mark
*3
No.
Yes
7. Command reception permission ON
8. Character entry
9. Command reception permission OFF
To save the character marked last, transmit
the "Overwrite file FOR" command.
MKM command
MCS or STR command
MKM command
47