Line Width / Filling Line Spacing: Wdc - Panasonic LP-GS Series Serial Communication Command Manual

3-12-5 Line width / filling line spacing: WDC

Sets the line width necessary to avoid crossing at marking intersection and the filling line spacing for bold characters and
bar codes.
• Settings by this command are applied to the object group No. 1000. To the object group No. 1000 the marking data
converted from LP-400/V files and the data set by LP-400/V compatible command mode belong.
⿎ Setting request data / response data for readout
Start
WDC
code command
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
WDC
code
⿎ Data description
Name
Line width
Filling line spacing
Total data length
⿎ Example of command settings
Condition: Line width = 0.2, Filling line spacing = 0.1
• Setting
Transmission data
• Readout
Transmission data
Response data
132
Sub [Line width] [Filling line spacing]
(Check
R End code
sum)
Data length
Data contents
[byte]
5 "0.010"–"2.000" [mm]
5 "0.010"–"2.000" [mm]
10 Fixed length.
[STX] WDC
[STX] WDC
[STX] WDC
ME-LP-GS-SR-COMP-3
10-byte
It is the segment width for the purpose of
calculation.
Applies to the value of the width for creating the
clearance at the intersection of lines comprising
characters.
• This setting is applied to both "bold filling line
spacing" and "bar code filling line spacing".
• In the response data for readout this value
represents the bold filling line spacing.
• The bar code filling line spacing specifies the
spacing of the marking lines for bar codes and
PDF417 modules.
S 0.2000.100
R [CR]
A 0.2000.100
(Check
End code
sum)
Remarks
[CR]
[CR]