Guide To Method Creation - GE AKTAavant Getting Started

6 Create a method

6.1 Guide to method creation

6.1 Guide to method creation
Introduction
This section describes how to create a new method based on a predefined method, and
how to edit a method. The section also provides an overview of the predefined methods
and phases that are available. You can create both purification methods and maintenance
methods. You can also add a maintenance phase at the end of a purification method.
For further information about method creation, see UNICORN 6 Method Manual.
Contents
This sections contains the following subsections:
Section
6.1.1 Create and edit methods
6.1.2 Predefined methods
6.1.3 Predefined phases
56 Getting Started with ÄKTAavant and UNICORN 6 28-9440-69 AB
See page
57
65
67